Pipe / Tube Connectors

Hello, I'm building some industrial models. Therefore I'm searching for some drafts/patterns/models for pipe/tube connectors like:

https://www.fenau.eu/rohrverbinder/b34-fur-o-33-7-mm-1.html

I was searching for it but I can't finde something. Maybe there is a library for this connectors?

---

Sent from the OpenSCAD mailing list archive at Nabble.com.

_______________________________________________
OpenSCAD mailing list
To unsubscribe send an email to [hidden email]

https://www.stlfinder.com/3dmodels/openscad+pipe/
Does that help

_______________________________________________
OpenSCAD mailing list
To unsubscribe send an email to [hidden email]

-- 
Ron Wheeler
Artifact Software
438-345-3369
[hidden email]

_______________________________________________
OpenSCAD mailing list
To unsubscribe send an email to [hidden email]

On Thu, May 27, 2021 at 04:46:21AM -0700, AndyY via Discuss wrote:
My strategy would be: "it's too much trouble and easier to just make
the models myself". That happens if I "cant find it" in 10 minutes.


Here:

pd = 30;
wt = 3;
dt = .1;

screwd = 5;


module halftube (l, sd=15)
{
  difference () {
    union () {
      difference () {
        translate ([0,0,-0.1]) cylinder (d=pd+2*wt, h=l);
        translate ([0,0,-1])   cylinder (d=pd+2*dt, h=l+2);
      }
      translate ([0,pd/2,sd])  rotate ([-90,0,0]) cylinder (d=10, h=wt+1);
    }
    translate ([0,pd/2-1,sd])  rotate ([-90,0,0]) cylinder (d=screwd, h=wt+3);
  }
}  


module pipe_t ()
{
  rotate ([0,0,0]) halftube (45, 30);
  rotate ([0,90,0]) halftube (30,0);
  rotate ([0,-90,0]) halftube (30,0);
}

module pipe_x ()
{
  rotate ([0,  0,0]) halftube (25, 0);
  rotate ([0,180,0]) halftube (25, 0);
  rotate ([0, 90,0]) halftube (45,30);
  rotate ([0,-90,0]) halftube (45,30);
}


//pipe_t ();
pipe_x ();



        Roger.



--
** [hidden email] ** https://www.BitWizard.nl/ ** +31-15-2049110 **
**    Delftechpark 11 2628 XJ  Delft, The Netherlands.  KVK: 27239233    **
f equals m times a. When your f is steady, and your m is going down
your a is going up.  -- Chris Hadfield about flying up the space shuttle.
_______________________________________________
OpenSCAD mailing list
To unsubscribe send an email to [hidden email]