NateTG
NateTG
Registered:
Groups: Anyone, Members, Registered
Posts in OpenSCAD
1234567
Show   Total: 129 items
Date Subject Count Location
Apparently inconsistent behavior in for loop: 1 reply OpenSCAD
Re: How to apply changes to all shapes generated in a for loop? 4 replies OpenSCAD
Re: Extrusion offset rather than taper 3 replies OpenSCAD
Re: difference() not working as expected with rotate_extrude() 1 reply OpenSCAD
Re: How do I bend? 4 replies OpenSCAD
Re: "Inside minkowski"? 2 replies OpenSCAD
Re: "Inside minkowski"? 1 reply OpenSCAD
Re: F5 works, then after an error, stops 9 replies OpenSCAD
Re: "Inside minkowski"? 7 replies OpenSCAD
Re: Re Spelling 0 replies OpenSCAD
Re: Re Spelling 3 replies OpenSCAD
Re: request center==centre 0 replies OpenSCAD
Re: Re Spelling 8 replies OpenSCAD
Re: Why are manifolds important? 1 reply OpenSCAD
Re: Why are manifolds important? 1 reply OpenSCAD
Re: Why are manifolds important? 8 replies OpenSCAD
Re: Why are manifolds important? 1 reply OpenSCAD
Re: Recursion detected in non-recursive function. 1 reply OpenSCAD
Re: Why are manifolds important? 0 replies OpenSCAD
Re: a bit off topic: detecting where support is needed 1 reply OpenSCAD
1234567