Re: Building problems - AMD-64, 64-bit (Giles Bathgate)

classic Classic list List threaded Threaded
5 messages Options
Reply | Threaded
Open this post in threaded view
|

Re: Building problems - AMD-64, 64-bit (Giles Bathgate)

Terry Gray
There's the rub...the latest CGAL requires libboost-thread >=1.35.1,
which is not installable in Ubuntu.

Reply | Threaded
Open this post in threaded view
|

Re: Building problems - AMD-64, 64-bit (Giles Bathgate)

kintel
Administrator
On Mar 28, 2010, at 17:40 PM, Terry Gray wrote:

> There's the rub...the latest CGAL requires libboost-thread >=1.35.1,
> which is not installable in Ubuntu.

The latest CGAL (3.6) requires boost 1.34.1. Where do you get the information about the 1.35.1 requirement from?

~/= Marius

--
We are Elektropeople for a better living.





Reply | Threaded
Open this post in threaded view
|

Re: Building problems - AMD-64, 64-bit (Giles Bathgate)

Giles Bathgate
In reply to this post by Terry Gray


On Sun, 2010-03-28 at 10:40 -0500, Terry Gray wrote:
> There's the rub...the latest CGAL requires libboost-thread >=1.35.1,
> which is not installable in Ubuntu.


I also have an AMD-64 system and ubuntu 9.10

I managed to get the various libraries to compile and install without
much trouble. And then got openscad to compile and run.

I have tried to document as much of this (from memory) here:

http://en.wikibooks.org/wiki/CGAL_From_Source

Regards

Giles Bathgate


Reply | Threaded
Open this post in threaded view
|

Re: Building problems - AMD-64, 64-bit (Giles Bathgate)

Len Trigg
Thanks for that - I was finally able to get the current openscad
compiled on my ubuntu 9.10 box!

I also needed to install libeigen2-dev that may be a new dependency
since last time I managed to compile an older openscad a couple of
months ago.

On Mon, Mar 29, 2010 at 9:04 AM, Giles Bathgate <[hidden email]> wrote:

> I also have an AMD-64 system and ubuntu 9.10
>
> I managed to get the various libraries to compile and install without
> much trouble. And then got openscad to compile and run.
>
> I have tried to document as much of this (from memory) here:
>
> http://en.wikibooks.org/wiki/CGAL_From_Source
>
> Regards
>
> Giles Bathgate
>
> _______________________________________________
> OpenSCAD mailing list
> [hidden email]
> http://rocklinux.net/mailman/listinfo/openscad
>

Reply | Threaded
Open this post in threaded view
|

Re: Building problems - AMD-64, 64-bit (Giles Bathgate)

kintel
Administrator
On Mar 31, 2010, at 05:41 AM, Len Trigg wrote:

> Thanks for that - I was finally able to get the current openscad
> compiled on my ubuntu 9.10 box!
>
Nice :)

When building on Linux, also keep and eye on the Mac build instructions at http://svn.clifford.at/openscad/trunk/doc/checklist-macosx.txt

They tend to not always be kept in sync and sometimes the Mac instructions are updated before the Linux ones.

~/= Marius

--
We are Elektropeople for a better living.