OpenSCAD and Woodworking

classic Classic list List threaded Threaded
5 messages Options
Reply | Threaded
Open this post in threaded view
|

OpenSCAD and Woodworking

runsun
This post was updated on .
Since we talked about a little bit woodworking in the other thread, I thought I might as well share my work designed in OpenSCAD. The project was finished, in fact, just a couple of days ago.
It is a shelf intended to be placed in the corner of a room:

Different colors with corresponding BOM:

Work in progress:

Done:

$ Runsun Pan, PhD
$ libs: scadx, doctest, faces(git), offline doc(git), runscad.py(2,git), editor of choice: CudaText ( OpenSCAD lexer); $ Tips; $ Snippets
Reply | Threaded
Open this post in threaded view
|

Re: OpenSCAD and Woodworking

treespiralcar
This post has NOT been accepted by the mailing list yet.
Nice design runsun, i built some myself using things from an abandoned factory and it was enough space to put half the things in the house. Shelves are fantastic :)
Reply | Threaded
Open this post in threaded view
|

Re: OpenSCAD and Woodworking

jnutt
This post was updated on .
In reply to this post by runsun
CONTENTS DELETED
The author has deleted this message.
Reply | Threaded
Open this post in threaded view
|

Re: OpenSCAD and Woodworking

MichaelAtOz
Administrator
jnutt wrote
Thanks for sharing.  I'm just starting with OpenScad and pretty new to coding also.  I will be mostly using it for woodworking to create parametric models.  Have you run across any helpful info on using for woodworking?
Hi Jnutt,
Welcome to the forum. Your post is still flagged as "This post has NOT been accepted by the mailing list yet", so nobody gets it unless they look.
You need to subscribe to the mailing list, and respond to the registration email.
Admin - email* me if you need anything,
or if I've done something stupid...
* click on my MichaelAtOz label, there is a link to email me.

Unless specifically shown otherwise above, my contribution is in the Public Domain; to the extent possible under law, I have waived all copyright and related or neighbouring rights to this work.
Obviously inclusion of works of previous authors is not included in the above.


The TPP is no simple “trade agreement.” Fight it! http://www.ourfairdeal.org/ time is running out!
Reply | Threaded
Open this post in threaded view
|

Re: OpenSCAD and Woodworking

jnutt
This post has NOT been accepted by the mailing list yet.
In reply to this post by runsun
Thanks for sharing.  I'm just starting with OpenScad and pretty new to coding also.  I will be mostly using it for woodworking to create parametric models.  Have you run across any helpful info on using for woodworking? I hoping to be able to print a cut list from openscad.  I'm wanting to be able to change my design and instantly update my list.