Controlling memory usage

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

Controlling memory usage

ro26
When I set $fs to its minimum ($fs=0.01) I start running into memory
problems, such as the message "WARNING: GeometryEvaluator: Node didn't
fit into cache".  The program slows down to a crawl as if it's paging.

FYI I'm running OpenSCAD version 2015.03-2 on debian 9 ('stretch'),
64-bit kernel.

I noticed that there are some cache related variables in the config
files.  Would changing any of these values help?  I haven't found any
documentation on them.

Is there a way of giving openscad more memory? I haven't seen anything
about this in the documentation or in the man page.

thanks



_______________________________________________
OpenSCAD mailing list
[hidden email]
http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org
Reply | Threaded
Open this post in threaded view
|

Re: Controlling memory usage

thehans
$fs = 0.01 is pretty insane.  That means the distance between each
vertex is about 1/100th of a millimeter.  That's going to generate a
ton of vertices on all but the smallest, simplest models.  Is there
any reason you want it so low?

I usually don't go below $fs = 0.2  on most things (depends on the
model) and that's already what I would consider pretty fine detail.

That said, if you still want to increase your cache size, you can do
so in Preferences -> Advanced -> Polyset cache size
On Wed, Sep 5, 2018 at 1:48 PM Barnet Wagman <[hidden email]> wrote:

>
> When I set $fs to its minimum ($fs=0.01) I start running into memory
> problems, such as the message "WARNING: GeometryEvaluator: Node didn't
> fit into cache".  The program slows down to a crawl as if it's paging.
>
> FYI I'm running OpenSCAD version 2015.03-2 on debian 9 ('stretch'),
> 64-bit kernel.
>
> I noticed that there are some cache related variables in the config
> files.  Would changing any of these values help?  I haven't found any
> documentation on them.
>
> Is there a way of giving openscad more memory? I haven't seen anything
> about this in the documentation or in the man page.
>
> thanks
>
>
>
> _______________________________________________
> OpenSCAD mailing list
> [hidden email]
> http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org

_______________________________________________
OpenSCAD mailing list
[hidden email]
http://lists.openscad.org/mailman/listinfo/discuss_lists.openscad.org